Table of Contents
Advertisement
Objects Moving in Perpendicular Direction Example
CO–DRIVER SYSTEM WITH FOLLOW TO
STOP - TRAFFIC JAM ASSIST
The Co-Driver system combines the features of Active
Cruise Control (ACC) and lane centering logic to control
the trajectory of the car's path, maintaining it as
close to the center of the lane as possible while also
managing speed.
This driving assistance system can be activated on all
types of roads.
The system information from the front camera to assist
you in keeping the car steadily centered in the lane at a
consistent speed.
O
PERATION
The system only works when the driver keeps their
hands on the steering wheel. If the system senses that
hands have been taken off the steering wheel, it will
notify you to place your hands back on the steering
wheel.
NOTE:
The Co-Driver system can take a few seconds to
activate once all conditions are met. During this time,
a grey indication will appear on the instrument panel
display and the system will be activated automatically
as soon as all conditions are met, without any
intervention by the driver.
Co-Driver System On/Off Button
The following conditions must be met before the Co-
Driver system turns on:
●
Activate the Co-Driver system by pressing the
button on the steering wheel.
●
Adaptive Cruise Control (ACC) must be in the ON.
●
The vehicle speed must be between 35 mph and 90
mph (60 km/h and 150 km/h).
●
Camera system functioning properly.
●
Turn signals must not be activated.
STARTING AND OPERATING
●
If the set speed is less than 35 mph (60 km/h) the
Co-Driver system will not work;
●
If the speed of Adaptive Cruise Control (ACC) can be
set to a higher than a top speed of 90 mph (150
km/h), the Co-Driver feature will not be available.
A
D
CTIVATION AND
EACTIVATION
To activate the system, press the
button on the
steering wheel.
To deactivate the system press the button again.
Suspension conditions
System operation are temporarily paused under the
following scenarios:
●
When the ACC system gets deactivated or inhibited
ð
page
79.
●
Tight bends in the road.
●
If the lines on the road are not detected accurately.
●
When one of the two lines on the road are is
damaged or broken.
●
When the sun is low, causing glare on the windshield
camera.
●
If the driver activates the left or right turn signal.
●
When the driver intentionally switches lanes without
using the corresponding turn signal.
●
In the event of system irregularities.
●
When the vehicle speed exceeds the maximum limit.
●
If lateral acceleration becomes too high.
87
4
Advertisement
Table of Contents
