Table of Contents
Advertisement
Multifunction lever (Vehicles Sold In Canada Only)
H
EADLIGHTS
To turn on the headlights, rotate the end of the
multifunction lever to the headlight position. When the
headlight switch is on, the parking lights, taillights,
license plate light, and instrument panel lights are also
turned on. To turn off the headlights, rotate the end of
the multifunction lever back to the O (off) position.
NOTE:
On vehicles sold in Canada, the rear parking lights, and
Daytime Running Lights (DRLs) will turn on when the
headlight switch is rotated to the O (off) position.
A
H
UTOMATIC
EADLIGHTS
This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
with the engine running, rotate the headlight switch to
the AUTO position.
To turn the automatic headlights off, turn the headlight
switch out of the AUTO position.
D
R
L
AYTIME
UNNING
IGHTS
The Daytime Running Lights (DRLs) are activated
with the switch in the AUTO position and in daylight
conditions.
NOTE:
With the ignition system in the ON/RUN position and
the propulsion system not active, the daytime running
lights are switched off.
NOTE:
On some vehicles, the Daytime Running Lights may
deactivate or reduce intensity on one side of the vehicle
(when a turn signal is activated on that side), or on both
sides of the vehicle (when the hazard warning lights are
activated).
A
C
(A
UTOMATIC LIGHTING
ONTROL
— D
S
USK
ENSOR
The light sensor is equipped with an infrared LED,
located on the windshield. It detects changes in light
intensity outside the vehicle, based on the sensitivity
of light set by using the menu on the display or on the
Uconnect system.
The higher the sensitivity, the lesser the amount of
external light required for controlling the lighting.
With the ignition system in the ON/RUN position,
rotate the switch to the AUTO position to activate the
"Automatic lighting control" function.
H
B
IGH
EAMS
To activate the high beam headlights, with the ignition
system in the ON/RUN position, push the multifunction
GETTING TO KNOW YOUR VEHICLE
lever forward (toward the front of the vehicle), and
an indicator will illuminate in the instrument cluster
display. The headlights must be in the ON position.
To deactivate the high beam headlights, pull the
multifunction lever rearward (toward the rear of the
vehicle).
A
H
UTOMATIC
IGH
— I
E
F
QUIPPED
In order not to dazzle other road users, the lights
are automatically deactivated when approaching cars
travelling in the opposite direction or when following a
car travelling in the same direction.
NOTE:
●
The Automatic High Beam Headlamp Control can
)
UTOLIGHT
be turned on or off by selecting "ON" under "Auto
Dim High Beams" within your Uconnect Settings
page
113, as well as turning the headlight switch to
the AUTO position.
●
Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will cause
headlights to remain on longer (closer to the
vehicle). Also, dirt, film, and other obstructions on
the windshield or camera lens will cause the system
to function improperly.
●
If the windshield or Automatic High Beam Headlamp
Control mirror is replaced, the mirror must be re-
aimed to ensure proper performance. See a local
authorized dealer.
39
2
B
H
C
EAM
EADLAMP
ONTROL
ð
Advertisement
Table of Contents
