Table of Contents
Advertisement
Instrument Panel Lock Button
●
LED ON: Doors locked. Push the central lock/unlock
button once to centrally unlock the front doors and
liftgate. The LED will switch off.
●
LED OFF: Doors unlocked. Push the central lock/
unlock button again to centrally lock the front doors
and liftgate. The doors will be locked only if all the
doors are properly closed.
WARNING!
●
When exiting the vehicle, always remove the key
fob from the vehicle and lock your vehicle.
●
Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
●
Allowing children to be in a vehicle unattended
is dangerous for a number of reasons. A child
or others could be seriously or fatally injured.
Children should be warned not to touch the
parking brake, brake pedal or the gear selector.
●
Do not leave the key fob in or near the vehicle,
or in a location accessible to children, and do
not leave the ignition of a vehicle equipped with
Keyless Enter-N-Go in the ON/RUN mode. A child
could operate power windows, other controls, or
move the vehicle.
●
Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up may
cause serious injury or death.
An unlocked car is an invitation. Always remove the
key from the vehicle and lock all doors when leaving
the vehicle unattended.
D
O
OOR
PENING
The door can be opened by pressing the button located
above each front door panel. If all doors are locked,
pressing the button on either door will unlock the
other door and liftgate. This ability can be activated or
deactivated via Uconnet Settings
NOTE:
Press the button three times in two seconds to open
the doors in motion at speeds above 3 mph (5 km/h).
Below 3 mph (5 km/h) doors will open at first press.
(Continued)
WARNING!
CAUTION!
ð
page
113.
GETTING TO KNOW YOUR VEHICLE
Power Door Button Opening
The doors can also be locked and unlocked with the
Keyless Enter 'n Go - Passive Entry system.
NOTE:
If the electronic key does not work, the doors can still
be opened from the inside by pulling the manual door
handle. For information on how to use the manual door
ð
handle, see
page
31.
K
E
'
G
™ — P
EYLESS
NTER
N
O
ASSIVE
The Passive Entry system is an enhancement to the
vehicle's Remote Keyless Entry system and a feature of
Keyless Enter 'n Go™. This feature allows you to lock
and unlock the vehicle's door(s) without having to push
the key fob lock or unlock buttons.
NOTE:
●
Passive Entry may be programmed on/off through
ð
Uconnect Settings
page
113.
29
2
E
NTRY
Advertisement
Table of Contents
