Table of Contents
Advertisement
108
STARTING AND OPERATING
Lane Sensed (Solid
Yellow Line/Solid Yellow Telltale)
●
When the LaneSense system senses the lane
has been approached and is in a lane departure
situation, the left lane line flashes yellow (on/off).
The LaneSense telltale changes from solid yellow to
flashing yellow. At this time torque is applied to the
steering wheel in the opposite direction of the lane
boundary.
For example: If approaching the left side of the lane
the steering wheel will turn to the right.
System Limited Operation Warning
If a dedicated message appears on the display, it
could indicate a condition that limits the system's
operation. Possible reasons for this limitation include
an obstruction blocking the camera's view or a system
fault.
If an obstruction is detected, clean the area of the
windshield near the interior rearview mirror and verify
if the message disappears. Even if the car can still be
driven under normal conditions, the system may not be
fully available.
Once the conditions restricting the system's functions
are resolved, it will return to its normal and complete
operation. However, if the fault continues, it's advisable
to get in touch with an authorized dealer for further
assistance.
No Hands On Steering Wheel Detection
When the system detects the absence of hands on
the steering wheel during active system intervention, it
will initiate a series of escalating visual and acoustic
warnings. This process will span 15 seconds, with the
goal of prompting the driver to place their hands back
on the steering wheel.
If the driver does not return their hands to the
wheel within this 15-second window, the system will
disengage and issue an additional warning lasting 5
seconds.
System Fault
If the system deactivates and displays a message on
the instrument cluster display, it signifies a fault within
the system. It is still possible to drive the car, but it is
strongly recommended that you contact an authorized
dealer.
PARKVIEW REAR BACK UP CAMERA
The ParkView Rear Back Up Camera allows you to see
an on-screen image of the rear surroundings of your
vehicle when the gear selector is put into REVERSE.
The image will be displayed on the touchscreen display
along with a note to "Check Entire Surroundings"
across the top of the screen. After five seconds this
note will disappear. The ParkView camera is located on
the rear of the vehicle on the boot tailgate.
Back Up Camera Location
When the vehicle is shifted out of REVERSE with
camera delay turned off, the rear camera mode is
exited and the navigation or audio screen appears
again.
When the vehicle is shifted out of REVERSE with
camera delay turned on, the camera image will
continue to be displayed for up to 10 seconds unless
the vehicle speed exceeds 8 mph (13 km/h), the
vehicle is shifted into PARK, or the ignition is placed
in the OFF position.
A touchscreen button to disable the camera is available
when the vehicle is not in REVERSE. Display of the
camera image after shifting out of REVERSE can be
disabled via Uconnect Settings.
When enabled, active guidelines are overlaid on the
image to illustrate the width of the vehicle and its
projected back up path based on the steering wheel
position.
Advertisement
Table of Contents
