Table of Contents
Advertisement
192
SERVICING AND MAINTENANCE
Replacing Interior Bulbs
REAR CARGO LAMP
1.
Using the screwdriver, extract the ceiling light
working in the point shown by the arrow.
Ceiling Light
2.
Open the protection and replace the snap-fitted
bulb.
Bulb Replacement
3.
Close the cover on the lens.
4.
Refit the ceiling light by inserting it correctly in its
housing, on one side and then pressing on the
other side until it clicks into place.
TIRES
T
S
I
IRE
AFETY
NFORMATION
Tire safety information will cover aspects of the
following information: Tire Markings, Tire Identification
Numbers, Tire Terminology and Definitions, Tire
Pressures, and Tire Loading.
Tire Markings
Tire Markings
1 — U.S. DOT Safety
4 — Maximum Load
Standards Code (TIN)
2 — Size Designation
5 — Maximum Pressure
3 — Service Description
6 — Treadwear, Traction
and Temperature Grades
NOTE:
●
P (Passenger) — Metric tire sizing is based on
U.S. design standards. P-Metric tires have the letter
"P" molded into the sidewall preceding the size
designation. Example: P215/65R15 95H.
●
European — Metric tire sizing is based on European
design standards. Tires designed to this standard
have the tire size molded into the sidewall beginning
with the section width. The letter "P" is absent from
this tire size designation. Example: 215/65R15 96H.
●
LT (Light Truck) — Metric tire sizing is based on
U.S. design standards. The size designation for
LT-Metric tires is the same as for P-Metric tires
except for the letters "LT" that are molded into the
sidewall preceding the size designation. Example:
LT235/85R16.
●
Temporary spare tires are designed for temporary
emergency use only. Temporary high pressure
compact spare tires have the letter "T" or "S"
molded into the sidewall preceding the size
designation. Example: T145/80D18 103M.
●
High flotation tire sizing is based on U.S. design
standards and it begins with the tire diameter
molded into the sidewall. Example: 31x10.5 R15 LT.
Advertisement
Table of Contents
