Table of Contents
Advertisement
182
SERVICING AND MAINTENANCE
grease, such as Mopar® Spray White Lube to ensure
quiet, easy operation and to protect against rust and
wear. Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit; after lubricating, excess oil and grease should be
removed. Particular attention should also be given to
hood latching components to ensure proper function.
When performing other underhood services, the hood
latch release mechanism, and safety catch should be
cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Autumn and Spring. Apply a small
amount of a high quality lubricant, such as Mopar®
Lock Cylinder Lubricant directly into the lock cylinder.
W
W
B
INDSHIELD
IPER
LADES
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth
and a mild nonabrasive cleaner. This will remove
accumulations of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always
use washer fluid when using the wipers to remove salt
or dirt from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact
with petroleum products such as engine oil, gasoline,
etc.
NOTE:
Life expectancy of wiper blades varies depending on
geographical area and frequency of use. If chattering,
marks, water lines or wet spots are present, clean the
wiper blades or replace as necessary.
Front Wiper Blade Removal/Installation
CAUTION!
Do not allow the wiper arm to spring back against the
glass without the wiper blade in place or the glass
may be damaged.
1.
Lift the wiper arm to raise the wiper blade off of
the glass, until the wiper arm is in the full upright
position.
Windshield Wiper Arm And Blade
1 — Wiper Blade
2 — Locking Button
3 — Wiper Arm
2.
To disengage the wiper blade from the wiper arm,
press the locking button.
3.
Insert the new blade making sure it is securly
locked into place.
4.
Gently lower the wiper arm onto the glass in the
original position.
Rear Wiper Blade Removal/Installation
1.
Lift the rear wiper arm pivot cap away from the
wiper arm to allow the rear wiper arm nut to be
exposed.
Wiper Pivot Cap In Unlocked Position
1 — Wiper Arm Pivot Cap
2 — Nut
2.
Undo the nut that secures it to the pivot pin;
remove the expired rear wiper arm and correctly
position the new arm and tighten the nut fully.
3.
Lower the cover back to original position and snap
the wiper pivot cap back into place.
4.
Lower the wiper blade onto the glass.
C
S
OOLING
YSTEM
The cooling system is sealed. Never try to refill the
cooling system. Always refer to an authorized dealer.
Advertisement
Table of Contents
