Table of Contents
Advertisement
76
STARTING AND OPERATING
While the system is in the "Ready" state, the driver
must press the SET (+), SET (–), or RES button to
engage the system. When the system is fully engaged
and detects the current speed limit using the TSA
system, the message in the instrument cluster display
will indicate the new detected speed limit by suggesting
the driver to press "RES" to accept it.
If the detected speed sign is greater than the current
set speed, an up arrow will be displayed too. If the
detected speed sign is lower than the current set
speed, a down arrow will be displayed instead. If the
driver accepts the new suggested speed sign, the
indicator light will change to green.
Pushing the SET (+) or SET (–) button on the right of the
steering wheel will raise and lower the set speed to a
desired value above or below the set ISA speed.
Pushing and holding down the SET (+) or SET (–) button
will increase/decrease the speed value by increments
of 5 mph (5 km/h).
NOTE:
The Cruise Control (if equipped) and Adaptive Cruise
Control (if equipped) systems will be unavailable while
the ISA system is in use.
E
T
S
S
XCEEDING
HE
ET
PEED
By fully pressing the accelerator pedal, the maximum
set speed can be exceeded while the system is active.
When the maximum set speed is exceeded, the green
indicator light will blink and the instrument cluster
display will show an override message for five seconds,
or until the accelerator pedal is released.
D
EACTIVATION
The system can be deactivated under the following
conditions. A message will appear in the instrument
cluster display to confirm that the feature has been
turned off.
●
When the Active Speed Limiter Button is pressed.
●
When the TSR system is deactivated.
●
When the TSR system shows a new speed limit
which is not confirmed by the driver.
●
When the TSR system shows the end of a speed
limit.
●
When the TSR system cannot display any speed
limit.
ISA can also be deactivated by pressing the CANC
button. In this case, the ISA system is not completely
turned off, and the driver can reactivate the system by
pressing the RES button.
TRAFFIC SIGN RECOGNITION SYSTEM
The Traffic Sign Reconition (TSR) system uses a camera
mounted on the windshield, as well as map data
when the vehicle is equipped with Navigation, to detect
recognizable road signs such as:
●
Speed limits
●
Speed limits with restrictions
●
No passing zones
NOTE:
●
The TSR system will automatically display the road
sign detected in the unit of measurement (mph or
km/h) selected within Uconnect Settings or within
the instrument cluster display.
●
If no speed limit signs are detected, the system will
revert to the speed limit signs that are stored in the
Navigation system.
●
The system always checks the traffic signs indicating
the current speed limit signs. The system is able to
recognize and display up to 3 different road signs in
the instrument cluster display.
●
The system will resume the last settings enabled
when the engine is shut off and turned back on.
A
/D
CTIVATION
EACTIVATION
The TSR System can be enabled/disabled within the
Uconnect system through the Safety/Driver Assistance
menu. System ON is signaled by road signs shown on
the instrument cluster display.
When the TSR system is turned OFF, the system will not
show any traffic signs.
When the Speed Limiter or Adaptive Cruise Control is
engaged, it will display the appropriate road speed limit
(whether it's a standard limit or adjusted for rain/snow/
foggy conditions). You can accept this displayed speed
as the setting for Intelligent Speed Assist, or you can
use it for Intelligent Adaptive Cruise Control by pressing
the RES button.
NOTE:
The TSR system cannot provide an applicable speed
limit in the following cases:
Advertisement
Table of Contents
