Advertisement
Available languages
Available languages
FLATFACE DIN/DETACHABLE FACEPLATE/PULLOUT (DIN-E) RADIOS
Slide the mounting sleeve (metal shroud) into the panel's radio opening and bend all available mount-
ing tabs outward (see inset). Slide the radio into the mounting sleeve once it has been fastened to the
kit panel until the radio locks into place.
NOTE: The mounting sleeve must be removed from the radio frst! Your radio may be snapped into
its sleeve. Slide the mounting sleeve (metal shroud) off the radio towards the back.
NOTE: REAR SUPPORT
STRAPS NOT INCLUDED.
REAR SUPPORTING THE
STEREO ADDS TO THE
INSTALLATION'S
STRUCTURAL INTEGRITY.
SHAFT MOUNT INSTALLATION NOTE:
SNAP SHAFT MOUNTING TABS NOT INCLUDED. IF
REQUIRED FOR YOUR STEREO INSTALLATION, CALL
800-821-36945 x3
USE THE APPROPRIATE SCOSCHE WIRING CONNECTOR BELOW
Wire up your new aftermarket stereo to the Scosche wiring connector and install the Scosche kit
and new stereo assembly in your vehicle. Follow the dash disassembly for your specif c vehicle in
reverse order to reassemble your dash.
CAR STEREO CONNECTORS
PROVIDE EASY CONNECTION OF YOUR CAR
STEREO TO FACTORY WIRING HARNESS.
FD021
1982-Up Ford, Lincoln,
Mercury vehicles
Non Premium/JBL Sound
CR012
1984-Up Chrysler
vehicles
QUICK START GUIDE
STEREO ASSEMBLY
REMOVE SLEEVE FROM STEREO
1. Locate the locking mechanism on your DIN stereo sleeve
(typically) on the side.
2. Slip mounting sleeve towards
rear of stereo and remove.
1550 MOUNTING PANEL
Remove the sections indicated.
Use side cutters, an X-acto
knife or hacksaw blade to cut
the top and bottom sections
(follow the cut lines) then simply
pull outward to break off each tab.
DIN MOUNTING SLEEVE
(SUPPLIED WITH STEREO)
DIN STEREO
STEREO'S SUPPLIED
FOR IMMEDIATE SHIPMENT.
STEREO CONNECTION
IM01A
1990-Up lmport,
Jeep, Mitsubishi
vehicles
MA01
1988-90 Mercury
Tracer
REAR SUPPORT STRAPS
2190 MOUNTING PANEL
TRIM PLATE
4
BEND TAPS
OUTWARD
Advertisement
