Parts List; Sold Separately; Factory Stereo Removal - Scosche GM5201AB Installation Manual

1. Main panel with built-in touch screen (*)
2. Stereo mounting bracket (left)
3. Stereo mounting bracket (right)
4. Dash pocket for single din mount
5. Power harness (not shown-see page 3)

SOLD SEPARATELY:

CAMOSM OnStar retention interface
(not shown -see page 3)
2010-UP CHEVROLET CAMARO
1. Turn ignition to the ON position and shift vehicle into drive.
NOTE: ln order to complete step 1 the battery must Ье connected. After completing
step 1, disconnect the negative battery саЫе and proceed to step 2.
2. Use а Panel-safe Removal Tool (PRl) to unclip Auxiliary gauge panel, unplug and remove.
3. Use а small flathead screw driver, unclip screw сар located оп the lower front side of the
shift knob.
4. Extract (1) Т-20 Torx screw to remove gear shift knob.
5. Extract (4) 7mm screws securing shifter console, then with pick tool, unclip (1) clip located
оп eachside under the shifter console, unplug and remove.
6. Use PRT to unclip each side panel from the center console.
7. Extract (1) Phillips head screw from each side located оп the outer area of the center
console.
8. Extract (1) Phillips head screw from each side of center console's rear panel, lift and pull
back to remove.
9. Extract (3) Phillips head screws behind center console's armrest.
10. Extract (1) Phillips head screw in front of beverage holder.
11. Use PRT to unclip 12V and USB/3.5mm housing inside the armrest, unplug and remove.
12. Use PRT to unclip center console and remove.
13. Extract (2) 7mm screws securing radio panel located under and to the rear of А/С controls.
Use PRT to unclip radio fascia panel, unplug, and remove.
14. Extract (4) 7mm screws securing radio chassis / Drive assemЫy, unplug, lift away
and remove.

PARTS LIST

FACTORY STEREO REMOVAL

2
2
cJ
cJ cJ
4
/ cJ
cJ cJ
cJ
cJ cJ
� �
3