Scosche FCJ2076 Installation Kit page 9

1987-93 Chrysler Le Baron "Coupe"
RADIO REMOVAL:
1. Remove two screws, one from each lower corner
of the radio/console trim panel.
2. Gently snap off the trim panel.
3. Remove two screws securing the right side panel of the console, one at top, one at bottom;
remove the side panel.
4. Remove two screws from the radio mounting bracket. Disconnect the wire harness, antenna
lead, and ground strap. Remove the radio.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
1990-95 Chrysler Le Baron GTC
RADIO REMOVAL:
1. Gently pry outward on the radio trim bezel
to release seven snap clips and remove.
2. Extract two hex head bolts holding radio in place and slide radio outward.
3. Unplug all power/speaker connectors, unplug antenna and unbolt ground strap-remove radio.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
1985-89 Chrysler Le Baron GTS
1985-89 Dodge Lancer
RADIO REMOVAL:
1. Remove eleven screws from the perimeter of the
dash trim panel and remove the trim panel.
2. Remove two anti-theft bolts (use Snap-On bit TTW12 for 1/4'' drive) which secure the radio
to the dash substructure; pull the radio out of the cavity, disconnect all wiring,
and remove the radio.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
AND DISCARD. FOR DIN ISO INSTALLATION, SEE PAGE 4.
Para la instalación de radios DIN ISO ver la página 4.
AND DISCARD. FOR DIN ISO INSTALLATION, SEE PAGE 4.
Para la instalación de radios DIN ISO ver la página 4.
#2190 PANEL
AND DISCARD. FOR DIN ISO INSTALLATION, SEE PAGE 4.
Para la instalación de radios DIN ISO ver la página 4.
#2190 PANEL
#2190 PANEL
9
Read pages 2-4 Read pages 2-4
for kit assembly. for kit assembly.
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior
Read pages 2-4 Read pages 2-4
for kit assembly. for kit assembly.
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior
Read pages 2-4 Read pages 2-4
for kit assembly. for kit assembly.
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior