Test Connection - Scosche MagicMount UQ01 Manual

TEST CONNECTION

Before proceeding to the installation please test the modules functionality by connecting the
provided universal power connector, refer to the wiring diagram below. Once the module is
connected, place the Qi-enabled device on the module and refer to the LED Status details on
the bottom of page 4 for specific details on the LED lighting. For technical assistance with the
installation please call or visit us on the web at:
1-800-363-4490 x1
NOTE: Power test can also be done
by connecting a Type-C USB power
connector to the MQUSM Qi Module
(Type-C power connector not included).
area for best power results.
RED: Tap the vehicle's 12V
power wire by clamping with
the provided harness
1. Tap into the vehicle's 12V power and ground wires using appropriate tools.
2. Next, color match the clamps to the vehicle's power and ground wire then connect them.
Note: Scosche recommends striping the clamping area on the vehicle's power and ground
wires for best connection.
3. If done correctly, module will light-up when the vehicle is turned on and the 12V power
socket will retain power.
I
www.scosche.com/contact
Red= Power
Wire strip clamping
I
11
Type-C to MQUSM
(Mod"le's powe, ,o"cc•J
I
ffi
Black:: Ground
Wire strip clamping
area for best power results.
Black: Tap the vehicle's
ground wire by clamping with
12V Power
the provided harness
Socket
5