Factory Stereo Removal - Scosche ITCGM01B Installation Manual

2010-14 CHEVROLET CAMARO
1. Turn ignition to the ON position and shift vehicle into drive.
NOTE: In order to complete step 1 the battery must be connected. After completing
step 1, disconnect the negative battery cable and proceed to step 2.
2. Use a Panel-safe Removal Tool (PRT) to unclip Auxiliary gauge panel, unplug and remove.
3. Use a small flathead screw driver, unclip screw cap located on the lower front side of the
shift knob.
4. Extract (1) T-20 Torx screw to remove gear shift knob.
5. Extract (4) 7mm screws securing shifter console, then with pick tool, unclip (1) clip located
on each side under the shifter console, unplug and remove.
6. Use PRT to unclip each side panel from the center console.
7. Extract (1) Phillips head screw from each side located on the outer area of the center
console.
8. Extract (1) Phillips head screw from each side of center console's rear panel, lift and pull
back to remove.
9. Extract (3) Phillips head screws behind center console's armrest.
10. Extract (1) Phillips head screw in front of beverage holder.
11. Use PRT to unclip 12V and USB/3.5mm housing inside the armrest, unplug and remove.
12. Use PRT to unclip center console and remove.
13. Extract (2) 7mm screws securing radio panel located under and to the rear of A/C controls.
Use PRT to unclip radio fascia panel, unplug, and remove.
14. Extract (4) 7mm screws securing radio chassis / Drive assembly, unplug, lift away
and remove.
Use the illustrations labeled
BEFORE and AFTER for
modification location requirement.
Using a cutting tool, cut the area
as shown shaded/highlighted in
the BEFORE illustration of the
dash cavity so that it looks like
the AFTER.
Proceed to either the single DIN
assembly instruction on the next
page(3) or double DIN on page
4 after completing the dash
modification for the kit.
©2017 SCOSCHE INDUSTRIES, INC.

FACTORY STEREO REMOVAL

DASH MODIFICATION
BEFORE
AFTER
2
ITCGM01B 05/17