Scosche FCJ2076 Installation Kit page 13

1976-80 Dodge Aspen
1976-80 Plymouth Volare
RADIO REMOVAL:
1. Remove four screws from the bottom of the dash panel.
Carefully pull the top portion of the panel out and remove the radio.
2. Remove two screws securing the radio to the dash and pull the radio out.
3. Disconnect power, antenna, and all speaker electrical connections.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
1974-78 Dodge Charger, Monaco
1978-79 Dodge Magnum XE
RADIO REMOVAL:
1. Remove four screws from the bottom edge of the radio dash panel.
2. Remove two screws from the top edge of the panel above the radio location.
3. Unscrew the retainer ring securing the remote mirror control and remove the panel.
4. Remove two screws securing the radio to the dash. Pull the radio out.
5. Disconnect power, antenna, and all speaker and electrical connections.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
1997-00 Dodge Dakota
1998-00 Dodge Durango
RADIO REMOVAL:
1. Extract three screws from the bottom edge of small center plastic
panel below steering column, pry out on panel to remove.
2. Use a panel removal tool to carefully pry out on the radio/dash panel, unsnap, unplug the left
side of the panel, and remove.
3. Extract two 10mm bolts holding radio in, unplug and remove radio.
USE THESE SUPPORT
TABS AS REQUIRED
Usar tantas de estas
pestañas como sea
necesario
USE THIS BRACKET
Usar este braquete
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS
Usar las pestañas sombreadas y los braquetes indicados. Cortar las pestañas restantes y descartarlas.
#2190 PANEL
AND DISCARD. FOR DIN ISO INSTALLATION, SEE PAGE 4.
Para la instalación de radios DIN ISO ver la página 4.
#2190 PANEL
AND DISCARD. FOR DIN ISO INSTALLATION, SEE PAGE 4.
Para la instalación de radios DIN ISO ver la página 4.
#2190 PANEL
AND DISCARD. FOR DIN ISO INSTALLATION, SEE PAGE 4.
Para la instalación de radios DIN ISO ver la página 4.
13
Read pages 2-4
for kit assembly.
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior
Read pages 2-4
for kit assembly.
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior
Read pages 2-4
for kit assembly.
REMOVE ALIGNMENT
PIN - BOTTOM
Sacar la clavija de
alineamiento - Inferior