Attaching/Removing Unit From Optional Running Gear - Miller Millermatic 355 Owner's Manual

5-11. Attaching/Removing Unit From Optional Running Gear

1
2
Turn off unit and disconnect input
power before performing any work
on unit or running gear.
1 Power Source
2 Running Gear Latches
To mount the machine to the running gear,
set the feet of the welder in the pockets on
top of the running gear. Rotate the four
latches into the vertical position and tighten
thumb screws to secure the running gear to
the machine.
To remove the machine, reverse the proc-
ess. Loosen the thumb screws, pull out and
rotate the latches to disengage the machine.
OM-288360 Page 25