Pulsed Mig Manual Mode - Miller Millermatic 355 Owner's Manual

6-10. Pulsed MIG Manual Mode

3
1 Pulse Button
2 Set-Up Button
3 Left Knob
4 Right Knob
5 Home Button
Press Pulse and Set Up buttons
In the Setup menu, rotate left knob to high-
light material and gas. Rotate right knob to
select material and gas being used.
Rotate left knob to highlight wire diameter.
Rotate right knob to select wire diameter
being used.
Press Home to return to welding mode.
Operation
Adjust right knob for proper wire feed speed
and adjust left knob to change arc length if
required. Arc length will default to 50. Refer
to electronic parameter chart (P. Chart) for
1
2, 5
proper Wire Speed setting for metal and
metal thickness being welded. All Pulse MIG
programs are set up with the gases listed in
the Pulse MIG welding chart. If alternate
gases are used, adjust arc length and/or arc
control to adjust arc characteristics. Occa-
sionally, you will see the text Pro-Set. Pro-
Set highlights in blue, recommended factory
settings for easy set-up and recall.
Arc Length
Arc length can be adjusted from 0-99. Ad-
justing the arc length will vary the length of
the welding arc cone. Pro Set default is 50
If a gas is used other than what is listed on
the Pulse MIG welding program chart, the
Arc Length can be adjusted to help custom-
ize your arc to the gas being used.
ON
OFF
279061-E
(99 Setting)
(0 Setting)
Low Setting
High Setting
Arc Control
Arc Control can be adjusted either from the
Home screen or in the Setup menu. Press
Setup button to enter Setup menu. Rotate
left knob to select Arc Control. The setting
can be adjusted from 0 to 50. All Pulse MIG
welding programs are designed with a de-
fault setting of 25. Using the right knob to
adjust the Arc Control setting will vary the
width of the welding arc cone. Pro Set de-
fault is 25.
If a gas is used other than what is listed on
the Pulse MIG welding program chart, the
Arc Control can be adjusted to help custom-
ize your arc to the gas being used.
OM-288360 Page 49
4