Pulsed Mig Auto-Set Mode - Miller Millermatic 355 Owner's Manual

6-9. Pulsed MIG Auto-Set
6
1 Auto-Set Button
2 Pulse Button
Press Auto-Set and Pulse buttons.
3 Wire and Gas Buttons
Use soft keys to select wire and gas for
Pulsed MIG.
4 Wire Diameter
Use soft key to select wire diameter.
OM-288360 Page 48
Mode
™
1
2
3
4
5 Material Thickness
Use soft keys to move cursor to left or right
to select material thickness.
6 Left Knob
Use left knob to fine tune arc length. Arc
length defaults to 50.
7 Right Knob
Use right knob to fine tune wire feed speed.
5
Arc Length
Arc length can be adjusted from 0-99. All
Pulse MIG programs are set with a default
value of 50. Adjusting the Arc Length will
vary the length of the welding arc cone.
If a gas is used other than what is listed on
the Pulse MIG welding program chart, the
Arc Length can be adjusted to help custom-
ize your arc to the gas being used.
ON
OFF
7
279061-E