Installing Optional Handles, Running Gear And Cooler - Miller PipeWorx 400 Owner's Manual

7-12. Installing Optional Handles, Running Gear And Cooler

A. Installing Running Gear and Cooler
1
OM-236891 Page 38
9
6 7
8
2
11 12
10
9
11
13
2
6
7
8
805302-D / 805141-C
1 Running Gear 234359
2 Cooler
3 Wheel 163463 (2)
4 Flat Washer 602250 (4)
5 Retaining Ring 121614 (2)
Install wheels on cylinder tray as shown.
Set cooler on running gear.
�
6 Flat Washer 602240 (4)
7 Lock Washer 602211 (4)
8 Screw 601944 (4)
14 Remove hardware bag and hose from inside
cooler. Secure cooler to running gear using
supplied flat washers, lock washers and
screws.
9 Power Source
Set power source on cooler.
Secure power source to cooler using same
hardware that was used to secure cooler to
running gear.
10 Cylinder Support Bracket
11 Bushing 170647 (2)
12 Bushing 004214 (1)
13 Screw 128237 (4)
14 Chain 188441 (2)
4
Install cylinder support bracket to rear of
3
power source and secure with supplied
screws. Install bushings and chains.
5
Turn Off welding power source,
disconnect input power.
If not installing a cooler, set power
source on running gear.
Do not pinch cooler power cord be-
tween cooler and welding power
source.