Optional Single Cylinder Running Gear Assembly Instructions - Miller Millermatic 355 Owner's Manual

5-10. Optional Single Cylinder Running Gear Assembly Instructions

1
3
allen_set
allen_wrench
needlenose
knife
pliers needlenose
3
heavy-duty workclamp
stripcrimp
solderiron
philips head wrench
3/8 in.
socket wrench
3/8 in.
torque screwdriver
nutdriver
1 Running Gear Assembly, Front torque wrench
2 Running Gear Assembly, Rear Single
Cylinder
3 Screws 1/4–20 x 1/2 in.
4 Tabs, Rear Single Cylinder
Block front casters to prevent movement.
wirecutter
Slide front tabs from rear running gear as-
hammer
airgun
sembly into bottom slots of front running
gear assembly. Install two 1/4-20 x 1/2 in
screws on sides of front running gear
OM-288360 Page 24
strapwrench
3
3
2
tools/
flathead
5
allen_set 6
7
steelbrush
knife
3
light-duty workclamp
heavy-duty workclamp
stripcrimp
crescent wrench
drill
3/8 in. chippinghammer
socket wrench
drill
assembly but do not tighten. Rotate rear
handream
running gear assembly up so the top of the
cylinder base pan is flush with the base of
the front running gear assembly. Install two
1/4-20 x 1/2 in screws to attach front running
gear assembly to rear running gear assem-
bly. Torque four screws to 65 in lb (7.34 N
m).
frontcutter
awl
Tabs must be located inside of flanges of
front running gear assembly.
hammer
airgun
4
tools/
philips head wrench
flathead philips head
7
nutdriver
steelbrush
wirecutter
light-duty workclamp
greasegun
handream
file
awl
crescent wrench
wrench
crescent wrench
chippinghammer
nutdriver
chippinghammer
frontcutter
283178-B
wirecutter
filterwrench
greasegun
filterwrench
5 Bracket, Upper Single Cylinder
6 Tubing, Running Gear Post
7 Screws 1/4-20 x 1 1/2 in
.
Install the running gear post tubing to the
cart with four 1/4-20 x 1 1/2 in screws lo-
cated in the rear. Install two 1/4-20 x 1/2 in paintbrush
screws located on each side. Torque screws
to 65 in lb (7.34 N . m).
file
frontcutter
paintbrush