Connecting Push/Pull Gun - Miller Millermatic 355 Owner's Manual

5-21. Connecting Push/Pull Gun

(2.4 mm)
philips head wrench
nutdriver
wirecutter
greasegun
file
OM-288360 Page 34
3/32 in.
3
2
crescent wrench
chippinghammer
5 4
frontcutter
filterwrench
paintbrush
Obtain gas cylinder and chain to running
gear, wall, or other stationary support so cyl-
inder cannot fall and break off valve.
1 Gun End
2 Gun Liner
3 Wire Outlet Guide
Trim excess liner from end of gun so no
more than 3/32 in. (2.4 mm) of liner extends
past wire outlet guide.
4 Gun Securing Knob
Loosen securing knob. Insert gun end
through opening until it bottoms against drive
assembly (make sure gun end does not
touch drive rolls). Tighten knob.
Be sure to change drive rolls to the proper
size and type.
5 10 Pin Gun Trigger Plug
Insert plug into receptacle, and tighten
threaded collar.
1