Table of Contents
Advertisement
Problem solving guide
Problem
You cannot open the
door with the sensor
control.
HydroCleaner (cleaning
agent) has been put in
the water container.
160
Cause and remedy
You have selected the
The sensor control does not respond when the
combination steam oven is switched off.
As soon as the combination steam oven is switched
on, the sensor controls will respond. If you want the
sensor controls to always respond even when the
combination steam oven is switched off, select the
|
Display
QuickTouch
There may be a technical fault.
If you need to open the door, e.g. because there is
still food in the oven compartment, you will need to
open the door manually (see end of this section).
If the problem occurs again, contact the Miele Cus-
tomer Service Department.
The instructions on the display were not followed.
To achieve an optimum cleaning result, the individual
steps of the cleaning process are coordinated with
each other. Always follow the instructions in the dis-
play (see "Cleaning and care – Care").
If the cleaning process with
started:
Switch the combination steam oven off to cancel
the cleaning process.
Empty the water container and rinse it thoroughly.
Restart
HydroClean
If the cleaning process has already been performed
with
:
HydroClean
In the wash phase, the entire system is rinsed several
times with fresh water. After the cleaning process is
complete, all cleaning agent residue is removed.
Start
HydroClean
|
Display
QuickTouch
|
setting.
On
HydroClean
.
again if necessary.
|
setting.
Off
has not yet
Advertisement
Table of Contents
