Table of Contents
Advertisement
Using the Transmitter
in Induction mode
1. Place the Transmitter over the service with the arrows on top of the case lid running in
2. Switch the Transmitter on and observe the battery level. Change batteries when indi-
3. Select 8 kHz or 33 kHz mode, adjust output if required.
4. Trace the path of the service using the Locator set to the same frequency. Refer to "2
• Work at least 10 m / 33 ft away from the Transmitter to avoid airborne signals. Reposi-
• Coupling efficiency is best at 33 kHz.
• The signal will couple to adjacent services dependent on depth and direction.
• Reducing the signal output can help to increase the battery life and the Transmitter is
DIGICAT 500i/550i, How to Use the Transmitter
1
line with the suspected direction of the service.
cated.
The tracing signal is induced directly onto the service from the internal aerial.
How to Use the Locator" for more information.
tion the Transmitter if required.
less likely to apply a signal to an adjacent service.
2
3
35
Advertisement
Table of Contents
