Leica DIGICAT 500i User Manual page 95

Hide thumbs Also See for DIGICAT 500i:

Table of Contents

3. Battery check

Battery status is momentarily indicated after the Audio / Visual display test. The battery level

indicator will indicate the condition of the battery. When the batteries need replacing the

battery indicator will flash. Use alkaline batteries. Replace all of the batteries at the same

time.

4. Inductive mode check

Turn on the Transmitter and Locator both set to 33 kHz mode. At a distance of 2 m/6.56 ft,

the Locator should detect and indicate with both the audio and visual indicators.

Change the Transmitter and Locator modes to 8 kHz and repeat. The speed of the audio

pulsed output of both Transmitter and Locator should slow down.

5. Output signal level check

Press the output level control button, the indicated power should reduce to minimum and

then increase with repeated presses until the maximum level is again reached.

DIGICAT 500i/550i, Functional Checks

2 m/6.56 ft

5 m/16.4 ft

Table of Contents

Digicat 550i