DIGICAT 500i/550i, How to Use the Conductive Rod
Using the Conductive
1. Insert the rod into the pipe, duct, conduit or drain until the desired length is in place.
2. Connect the cable set to the Transmitter socket and the rod socket in the middle of the
Rod in Sonde mode
3. Switch the Transmitter on and select 8 kHz or 33 kHz.
4. Trace the length of the rod using the Locator set to the same frequency.
At least half the Conductive Rod needs to be uncoiled when in use.
frame. The black cable must be connected directly between Transmitter and Conductive
Rod.
A good signal output is indicated when the audible output from the Transmitter is
constant. The majority of the signal is concentrated towards the Sonde.
40