Table of Contents
Advertisement
DIGICAT 500i/550i, How to Use the Transmitter
3.3
How to Locate a Service Using the Transmitter
Start up test
The following test sequence will take place every time the Transmitter is activated.
On test
Audio output
LEDs
Battery low indication
Default mode selection
Test pattern
8KHz
1
On throughout test sequence.
LEDs are all lit throughout the test sequence.
Battery level is shown throughout the test sequence,
flashes if batteries are low.
33 kHz and maximum output level are automatically
selected. Induction mode output is selected unless the
transmitter's cable set or accessories are connected.
33KHz
34
Advertisement
Table of Contents
