Cleaning Your Atv - KYMCO MXU 270i EURO Manual

CLEANING YOUR ATV

Frequent and thorough cleaning of your ATV will not only
enhance its appearance but will improve its general
performance and extend the useful life of many components.
Additionally, thorough cleaning will help you to become
familiar with your ATV and you will be able to recognize
changes in its condition that will alert you that the vehicle
requires service or repairs. This will assist you in making sure
your ATV is safe for you and others to operate.
1. Before cleaning the ATV:
A. Block the end of the exhaust pipe to prevent water
entry. Use a commercially available, tapered rubber
plug or a plastic bag with a strong rubber band to
cover the end of the exhaust.
B. Make sure the spark plug and all fluid/oil filler caps
are properly installed.
C. Remove any items, such as the tool kit or Owner's
Manual that could be damaged by water during
cleaning. After cleaning, stow these items in plastic
bags within the storage compartments.
2. If the engine case is excessively dirty or greasy, apply
degreaser with a paint brush. Do not apply degreaser to the
drive chain and sprockets (if equipped) or the wheel axles.
PERIODIC MAINTENANCE
Excessive
deterioration of wheel bearings, brakes, engine and
transmission seals and electrical devices. Expensive repair
bills can result from high-pressure water and detergent
intrusion, which can be caused by a coin-operated car wash
or even a small, home-style pressure washer. Damage
caused by water intrusion of this type is not a defect, and
repairs are not covered by the KYMCO Limited Warranty.
3. Rinse the dirt and degreaser off with a garden hose under
normal pressure. Use only enough water pressure to rinse
the engine clean.
4. Once the majority of the dirt has been rinsed off, wash all of
the surfaces with warm water and a mild, detergent- type
soap. Small brushes, such as a tapered bottle brush or and
old toothbrush, are effective for cleaning hard-to- reach
areas.
5. Rinse the ATV off immediately with clean water and dry all
surfaces with a chamois, clean towel of soft absorbent cloth.
6. If the ATV is equipped with a chain, dry the chain and
lubricate it to prevent rust.
101
water pressure may cause water and