KYMCO MXU 270i EURO Manual page 20

1. Battery Low Voltage Warning
It flashes when the battery voltage is too low
2. Foot Brake Fluid Level Warning
It flashes when the Foot Brake Fluid Level is too low, you
should add some brake fluid to the brake reservoir.
3. CELP Indicator
The CLEP indicator will illuminate if a fault is detected in the
ATV's engine, fuel or electrical systems. If the CLEP indicator
stays lit, take your ATV to a KYMCO dealer for service as
soon as possible.
 NOTE: To check if the CELP indicator is functioning
properly, turn the ignition switch to the "ON" position
without starting the engine. The CLEP indicator still
illuminate, after starting it will clear out. If there is a
malfunction the CLEP indicator still illuminate,
4. Neutral Gear Position Indicator
The indicator light up when gear shifts to neutral gear
position.
5. High Beam Indicator
The high beam indicator will light up when the headlight
switch is turned to High beam.
CONTROL LOCATIONS & FUNCTIONS
6. Parking Brake Indicator
It indicates if the parking brake is applied or not.
7. Coolant Temperature Warning Indicator
When the coolant temperature reaches a specified level,
this indicator comes on. If the indicator comes on during
operation, stop the engine quickly and allow the engine to
cool down for about 10 minutes.
8. Speedometer
Indicates the approximate ATV speed in miles per hour
(MPH) or kilometers
9. Engine Tachometer
This circular gauge displays the engine's revolutions per
minute (RPM) on a calibrated analog dial.
10. Fuel Gauge*
The fuel gauge shows the approximate fuel supply available
in a graduated display. The normal operating fuel range is
with the section between the segments F to E or fuel
indicator. When the low fuel level warning indicator
flashes, fuel will be low and you should refill the tank as
soon as possible.
*Read following pages for more information.
15