Adding To An Existing Installation - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation
14. Click the Launch Windows Driver Management Console button to configure the ports or device
properties.
15. Return to the Installation wizard and click Close.
16. If necessary, go to Configuring COM Port Properties on Page 47 to configure the COM port properties.
17. If desired, go to Configuring Device Settings on Page 43 to set up advanced device properties (device
name and starting COM port number).

3.5. Adding to an Existing Installation

Use the following procedure to add a DeviceMaster or RocketPort to an existing installation.
1. Close any applications that are using serial ports before the device driver installation.
2. RocketPort: Install the adapter and connect the interface (Quadcable, Octacable, or interface box).
DeviceMaster: Connect the DeviceMaster to your network and use PortVision DX to program the IP
address.
If you need hardware installation procedures, see https://www.pepperl-fuchs.com.
Do not connect RS-422/485 devices until the appropriate port interface type has
been configured in the device driver. The default port setting is RS-232.
Caution
3. RocketPort: Click Cancel if a Found New Hardware message appears.
4. From the Start button, click Pepperl+Fuchs> Product Driver Installation Wizard.:
5. Click the Yes button to the Do you want to allow this app to make changes to your device message.
6. Click Next to start the Windows Driver Management Console.
7. Click Install and Next.
8. Click Next and follow the Installation Wizard for the remainder of the installation steps if needed.
• RocketPort: Refer to Step 11 on Page 20
• DeviceMaster: Refer to Step 12 on Page 21,
27