Program The Ipv4 Address (Network Information) - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

2.4. Program the IPv4 Address (Network Information)

If you have not done so, program the IPv4 address for your network. The following procedure is to program a
single DeviceMaster, if you want to program IPv4 addresses into multiple DeviceMasters, refer to the
PortVision DX help system or the ICDM-RX/TCP Installation and Configuration Manual.
Default Network Settings
• IPv4 address: 192.168.250.250
• IPv4 Subnet mask: 255.255.0.0
• IPv4 Gateway address: 192.168.250.1
1. If necessary, start PortVision DX, Start > Pepperl+Fuchs > PortVision DX.
2. If the DeviceMaster that you want to program is not displayed, click Scan.
3. Right-click the DeviceMaster in the Device Tree or Device List pane for which you want to program network
information and click Properties.
Note: Optionally, you can double-click the DeviceMaster and PortVision DX opens the Properties page.
12