Device Driver Installation; Installation Overview; Devicemaster; Rocketport - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

3. Device Driver Installation

This section discusses the following topics:
• Installation Setup Wizard on Page 18 for initial installation procedures
• Checking the Device Driver Version on Page 23
• Updating the Device Driver on Page 23
• Adding to an Existing Installation on Page 27

3.1. Installation Overview

Windows Driver Management Console specific installation instructions for the DeviceMaster and RocketPort
are discussed below.

3.1.1. DeviceMaster

If there is an NS-Link device driver already installed on your system for the DeviceMaster, use the following
discussions:
• Updating the Device Driver on Page 23 if you want to update the existing driver.
• Adding to an Existing Installation on Page 27 to add more DeviceMasters to the existing installation.
If you have performed the following procedures, you can skip to Installation Setup Wizard to start NS-Link
device driver installation.
You can use Before Installing the DeviceMaster Driver on Page 8 for procedures for these steps.
1. Install the DeviceMaster.
2. Install PortVision DX.
3. Program the network information (IP address) using PortVision DX.
4. Upload the appropriate version of SocketServer firmware.

3.1.2. RocketPort

If there is a device driver already installed on your system for the RocketPort, see Updating the Device Driver on
Page 23 or Adding to an Existing Installation on Page 27.
17