Loading A Driver Configuration File; Loading Device Configuration - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

5.3. Loading a Driver Configuration File

You must have previously saved a configuration file before you can load a configuration file. The driver
configuration file uploads in portions:
• If you highlight a device and click Load Configuration and Apply for the
parameters to reload on the device.
• To load port-level configuration parameters, you must highlight a single port and click Load Configuration
and Apply. You must upload each port's configuration parameters separately.

5.3.1. Loading Device Configuration

Use the following procedure to load the configuration file for device-level information for your device.
1. If necessary, open the Windows Driver Management Console.
2. Depending on your operating system, you may need to click Yes to the Do you want to allow the following
program to make changes to this computer? User Account Control message.
3. In the left pane, highlight the device for which you want to load the device-level settings from the
configuration file.
4. Click Load Configuration.
5. Browse to the location of the configuration file that you want to load.
6. Highlight the configuration file and click Open. The configuration file loads in a few moments.
7. Make the appropriate choice for your situation:
• Click No to the message, if you are using the file to set up multiple devices with the same device-level
settings.
• Click Yes to the message, if you are using the file to restore a specific device.
Note: DeviceMaster: Make sure that if this a configuration from another DeviceMaster, you must either
select the correct MAC address from the drop list or enter the correct MAC address. In addition,
make sure that the correct IP associated with this DeviceMaster.
8. Click Apply so that the configuration is saved on the device.
9. Go to the next procedure if you want to restore port settings from a configuration file.
device-level configuration
62