Using The Advanced Tab - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation
Ports
• The STATUS LED on the device is lit, indicating you have power and it has completed
the boot cycle.
Note: The STATUS LED flashes while booting and it takes approximately 15 seconds
2
• If the LINK (green) LED is lit, it indicates a working Ethernet connection.
• If the ACT (yellow) LED flashes, it indicates network activity.
• The PWR LED on the front of the unit is lit, which indicates it has power and has
completed the boot cycle.
Note: The PWR LED flashes while booting and it takes approximately 15 seconds for
4, 8,16
External power
supply
• The red LNK/ACT LED is lit, which indicates a working Ethernet connection.
• If the red 100 LED is lit, it indicates a working 100 MB Ethernet connection (100 MB
network, only).
• The Status LED on the front of the unit is lit, which indicates it has power and has
completed the boot cycle.
Note: The Status LED flashes while booting and it takes approximately 15 seconds
16, 32
Internal power
supply
• The red LNK/ACT LED is lit, which indicates a working Ethernet connection.
• If the red Duplex LED is lit, it indicates full-duplex activity.
• If the red 100 LED is lit, it indicates a working 100 MB Ethernet connection (100 MB
network, only).

7.3.5. Using the Advanced Tab

You can use the Advanced tab to get a summary of the DeviceMaster status. The Advanced tab can be useful
for troubleshooting network problems with your DeviceMaster.
Note: To use the Advanced tab, you must associate a MAC address to the DeviceMaster before
programming an IP address (Page 36).
Use the following procedure to access the Advanced tab.
1. If necessary, access the Windows Driver Management Console.
2. Highlight the DeviceMaster.
DeviceMaster Network LEDs
for the Bootloader to complete the cycle. When the Bootloader completes the
cycle, the LED has a solid, steady light that blinks approximately every 10
seconds.
the bootloader to complete the cycle. When the Bootloader completes the
cycle, the LED has a solid, steady light that blinks approximately every 10
seconds.
for the bootloader to complete the cycle. When the Bootloader completes the
cycle, the LED has a solid, steady light that blinks approximately every 10
seconds.
73