Device Driver Configuration; Overview; Devicemaster; Rocketport - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

4. Device Driver Configuration

4.1. Overview

This chapter discusses driver configuration for the Windows Driver Management Console.

4.1.1. DeviceMaster

If you programmed an IPv4 address into the DeviceMaster for your network using PortVision DX before
installing the NS-Link device driver; first associate the MAC address to the DeviceMaster and then configure
the driver with the IPv4 address that you programming into the DeviceMaster using PortVision DX.
DeviceMaster Driver Configuration Overview on Page 28 provides configuration procedures.

4.1.2. RocketPort

The RocketPort driver configuration discussions are available.
• Using the Windows Driver Management Console on Page 30
• Configuring Device Settings on Page 43
• Configuring COM Port Properties on Page 47

4.2. DeviceMaster Driver Configuration Overview

This subsection provides information for the DeviceMaster driver configuration.
• NS-Link Device Driver Configuration Considerations
• Using the Windows Driver Management Console on Page 30
• DeviceMaster Associating the MAC Address on Page 36
• Using the Driver in IPv4 Mode on Page 39
• Using the Driver in IPv6 Mode on Page 40
• Enabling SSL on Page 41
• Configuring Device Settings on Page 43
• Configuring COM Port Properties on Page 47
• DeviceMaster Network Configuration on Page 52
- Disabling IPv4 Mode on Page 52
- Changing a Static IPv4 Address on Page 53
- Setting Up DHCP (IPv4) on Page 54
• Configuring DeviceMaster Ports as Sockets on Page 56
• Enabling Secure Data Mode on Page 58
28