Program The Ipv6 Address (Network Information) - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

2.5. Program the IPv6 Address (Network Information)

You must use DeviceMaster web page to program an IPv6 address. You can refer to www.ipv6.com for
information about IPv6.
Default Network Settings
• IPv4 address: 192.168.250.250
• IPv4 Subnet mask: 255.255.0.0
• IPv4 Gateway address: 192.168.250.1
You may want to use PortVision DX to program an IPv4 address so that you can open the DeviceMaster web
page without changing your system IP settings to communicate with DeviceMaster.
Use the following procedure to program an IPv6 address.
1. Open your browser and enter the DeviceMaster's IP address.
2. Click the Network tab.
3. Optionally, configure a Host Name or change any of the General options.
4. Under IPv6, either select Use DHCPv6 or User static config below option.
5. If you selected a static address, enter the IPv6 address, Prefix Length, and if necessary, the Gateway.
6. Click the Save button.
Note: You must reboot for changes on this page to take affect.
7. Click the System tab and then click the Reboot option.
8. Optionally, click the Reboot Now button or let the web page reboot using the timer.
9. Go to Check the SocketServer Version on Page 15 to verify that you have the latest SocketServer version.
14