Uploading Socketserver - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

2.7. Uploading SocketServer

The NS-Link device driver loads the current firmware but not until the DeviceMaster has shown that an old
version of the SocketServer (older than 8.00) or any firmware other than NS-Link Updater is running. The driver
does not upload anything unless it first connects to the default application (SocketServer) on the DeviceMaster.
Optionally, you can upload the appropriate version of SocketServer after running the NS-Link device driver
Installation Setup Wizard.
Use the following procedure to upload the latest SocketServer version using PortVision DX.
1. Start PortVision DX, click: Start > Pepperl+Fuchs > PortVision DX.
2. Right-click the DeviceMaster or DeviceMasters of which you want to upload the latest version of
SocketServer and then click Advanced > Upload Firmware.
3. Browse to the location where you downloaded SocketServer, highlight the file, and click Open.
4. Click Yes to the Upload Firmware popup.
5. Click Yes to the second Upload Firmware popup.
You can click Refresh to verify that the upload has been
successfully completed.
If the upload fails, use the PortVision DX General tab on the
Properties screen to change the Bootloader Timeout to 45
seconds and then repeat Steps 2 through 5.
16