Loading Port Configuration - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

5.3.2. Loading Port Configuration

Use the following procedure to load the configuration file for port-level settings for your device.
Note: Device driver configuration files must be for the same model with the same port density. For example,
you cannot load a configuration file for a 32-port DeviceMaster onto a 4-port or a RocketPort EXPRESS
configuration file with the same port density onto a RocketPort INFINITY.
1. If necessary, open the Windows Driver Management Console.
2. Depending on your operating system, you may need to click Yes to the Do you want to allow the following
program to make changes to this computer? User Account Control message.
3. In the left pane, highlight the port for which you want to load the port-level settings from the configuration
file.
4. Click Load Configuration.
5. Browse to the location of the configuration file that you want to load.
6. Highlight the configuration file and click Open. The configuration file loads in a few moments.
7. Make the appropriate choice for your situation:
• Click No to the message, if you are using the file to set up multiple devices with the same port-level
settings.
• Click Yes to the message, if you are using the file to restore a specific device.
Note: Make sure that you do not duplicate COM port numbers. Simply change the COM port number
assignment before applying the changes.
8. Click Apply so that the configuration is saved on the device.
9. Repeat Steps 3 through 8 for each port that you want to restore.
63