Setting Up Dhcp (Ipv4) - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation
If you do not reboot the DeviceMaster at this time, the IP address is not implemented on the DeviceMaster.
Failure to reboot at this time can cause network communication problems later, if the IP address is not
programmed into the DeviceMaster. Pepperl+Fuchs support recommends rebooting the DeviceMaster at
this point.
10. Click Close to return to the Device General tab.
11. Optionally, you can click the Advanced tab and verify that the Device Status message indicates that the
Device is active and Ok.
12. After programming the IP address, you may need to do the following:
• Configure device properties, see Configuring Device Settings on Page 43.
• Configure COM port properties, see Configuring COM Port Properties on Page 47.
• Configure any of the DeviceMaster ports as sockets, see Configuring DeviceMaster Ports as Sockets
on Page 56.

4.7.3. Setting Up DHCP (IPv4)

After associating the DeviceMaster with the MAC address you can configure the driver to work using DHCP.
1. Before programming an IP address it is critical that the DeviceMaster be operational (the PWR or Status
LED is lit) when configured for the MAC address (DeviceMaster Associating the MAC Address on Page 36).
Note: If the DeviceMaster is NOT operational, do NOT attempt to
program or use an IP address with the DeviceMaster.
2. Highlight the Device Name of the DeviceMaster that you want to
configure.
3. Click the IPv4 Mode radio button.
4. Click the Network Settings button.
5. Click the Modify button.
6. Click DHCP IP. This option allows DHCP to assign the IP address.
Make sure that you provide the MAC address of the DeviceMaster
for the network administrator to assign a static IP address from
the pool. The DHCP server should assign the IP address, mask,
and IP gateway.
7. Click Apply Changes.
8. Click Yes to the WARNING popup message.
54