How To Configure Com Port Properties; How To Save Changes - Pepperl+Fuchs ICDM-RX/TCP Manual

ICDM-RX/TCP (DeviceMaster) and ICRPC (RocketPort EXPRESS)
Windows Driver Installation

4.3.6. How to Configure COM Port Properties

To change a port's properties for a product,
highlight the port of the product that you want to
configure in the Tree View pane. Make any
necessary changes:
• Click Apply to save the changes, which
saves the changes and leaves the Windows
Driver Management Console open.
• Click Ok to save the changes and close the
Windows Driver Management Console.
• Click Cancel to undo the changes and
close the Windows Driver Management
Console.
If you click another port or device name without
saving the changes, the Windows Driver
Management Console will prompt you to Apply,
Ignore, or Cancel the changes.
For more information, see Configuring COM
Port Properties on Page 47.
After saving the port changes, if desired, you can click Apply These Settings to All Ports to populate the
remaining ports with these COM properties.
Note: Not all products support the Terminate Resistor Options feature.

4.3.7. How to Save Changes

The Windows Driver Management Console indicates that changes have been made on this screen with a red
frame that identifies which device's General tab you are editing.
• Clicking the Apply button saves the changes on the tab and leaves the Windows Driver Management
Console open for further configuration.
• Clicking the Ok button saves the changes on that tab and closes the Windows Driver Management
Console.
• Clicking the Cancel button cancels the
changes on that tab and closes the
Windows Driver Management Console.
Note: The red frame around Port
indicates that the change has not
been saved.
35