Section Iv Service; Service Schedule; Component Replacement Schedule; Burner Head And Electrode/Sensor Assembly - Wayne LC2300M Manual

Qualified personnel may only perform burner service and maintenance. Operational checks of components and
in-line safety system at each service is necessary.
A: SERVICE SCHEDULE
It is recommended that servicing be conducted once a year or after 3,000 hours of operation by qualified
personnel. During service, perform operational checks on all safety systems and components.
Burner
Electrodes
Motor
Fan Wheel
Leak Check
Inspection of Electrical
B: COMPONENT REPLACEMENT SCHEDULE
LMV Control Unit
Valve Control System (Double Valve
Body, Regulating, Safety)
Gas Pressure Switch (High and Low)
Air Pressure Switch
Damper Motor (Air and Gas)
C. BURNER HEAD AND ELECTRODE/SENSOR ASSEMBLY
The burner head, electrodes, and manifold pipe are part of the burner head assembly. To remove the
burner head assembly, follow the procedure outlined below:
1. Disconnect the union fitting closest to the burner in the gas pipe train.
2. Remove the four Allen head screws that hold the manifold pipe to the burner
63899-002 Rev. A 3/20/2024
Make sure that the main gas valves and electrical power disconnect are turned
off before opening the burner or removing any parts for service. All cover
plates, enclosures, and guards must always be in place, except during
maintenance and servicing.
housing and remove the manifold pipe, see Figure 13.
SECTION IV
SERVICE
1 year
Replacement/cleaning - 1 year
1 year
1 year – Replace if need for cleaning/imbalance
1 year
1 year
10 years
10 years
10 years
10 years
N/A
48