Wayne LC2300M Manual page 25

18. Upon completion of the startup cycle, the screen will display the factory programmed or
user re-programmed ignition set point as shown below. The values within the pictures
below are examples.
NOTE: WHEN THIS SCREEN APPEARS, THE BURNER IS READY TO IGNITE AND
WILL DO SO UPON PRESSING THE "+" BUTTON. DO NOT PROCEED UNLESS YOU
HAVE CONFIRMED IT IS SAFE TO IGNITE BURNER.
Ignition Set Point
63899-002 Rev. A 3/20/2024
Ph 24: Drive to pre-purge position
Ph 30: Pre-Purge (Number on right of
screen counts down from 30 seconds)
Ph 36: Drive to ignition setpoint
Fuel Actuator
Angle (0-90)
Air Actuator
Angle (0-90)
25