Wayne LC2300M Manual page 43

21. Upon completion of the startup cycle, the screen will display the factory programmed
ignition set point as previously programmed in Step 14.
NOTE: WHEN THIS SCREEN APPEARS, THE BURNER IS READY TO IGNITE AND
WILL DO SO UPON PRESSING THE "+" BUTTON. DO NOT PROCEED UNLESS YOU
HAVE CONFIRMED IT IS SAFE TO IGNITE BURNER.
22. After confirming all safety systems are in place and you are ready to ignite the burner, press the "+"
button. The burner will go through the ignition cycle, Phase 38, 40, 42 and 44.
63899-002 Rev. A 3/20/2024
Ph 12: Burner standby
Ph 22: Burner, Safety Valve, and Fan
On
Ph 24: Drive to pre-purge position
Ph 30: Pre-Purge (Number on right of
screen counts down from 30 seconds)
Ph 36: Drive to ignition setpoint
43