Wayne LC2300M Manual page 18

H.1 BURNER HEAD ADJUSTMENT:
From Tables 1 and 2, find the Burner Head Setting (Dimension "A") for the desired flow rate at
which the burner will be operating. Referencing Figure 8, adjust the burner head by loosening
the both the jam nut that locks the burner head adjusting screw and the black nut along the side
of the burner. Without loosening the nut along the side, the adjustment screw mounting bracket
is likely to break.
Using a 5mm Allen wrench, adjust the burner head while measuring from the end of the air
tube to the front of the burner head, referencing Figure 7. Once Dimension "A" is achieved, re-
tighten the jam nut.
Burner Head Setting Dimension "A"
Figure 7
NOTE: BURNER HEAD SETTING WILL FACTORY SET 'DIM A' BETWEEN 3"
AND 3.25". BASED ON APPLICATION, FURTHER SCREW ADJUSTMENT MAY BE
REQUIRED TO ADJUST FLAME SHAPE (REFERENCE FIGURE 8). THE LARGER
THE HEAD SETTING, THE SHORTER AND BUSHIER THE FLAME. THE
SMALLER THE SETTING, THE LONGER AND LEANER THE FLAME.
63899-002 Rev. A 3/20/2024
18