Adjusting Settings Of Previously Set Azl - Wayne LC2300M Manual

NOTE: ABOVE REPRESENTS THE MOST COMMON FAULT CODES A USER MAY
EXPERIENCE. FOR A COMPREHENSIVE LIST OF FAULT CODES PLEASE SEE PAGES 138 –
159 OF THE LMV3 MANUAL EITHER BY SCANNING THE QR CODE BELOW OR FOLLOWING
THE PROVIDED URL. HTTPS://SCCCOMBUSTION.COM/WP-
CONTENT/UPLOADS/2023/10/LMV3-TECHNICAL-INSTRUCTIONS-LV3-1000-INDEXED.PDF
E: ADJUSTING SETTINGS OF PREVIOUSLY SET AZL
If any adjustment is needed for fuel and air values after the control settings have already been
finalized, the control will need reprogrammed. By following the steps outlined below, new values can
be easily programmed.
1. Apply 120VAC power to burner, either directly or by way of the appliance control.
2. Note the status on the screen of the AZL display and proceed as follows:
a. The status should indicate OFF. This indicates that the burner has already been
63899-002 Rev. A 3/20/2024
fully programmed and has been finalized.
Loc:d: This display shows the current
diagnostic code.
To reset the fault, press and hold
"Enter" for 1...3s, rESEt will appear
on the screen. When the button is
released, the control unit is reset.
39