Table of Contents
Advertisement
Installation
Split Wood Kit 1705SWKV2
Material required
• Black steel platform (supplied with appliance)
• Split Wood Kit, which contains:
• 9 logs (numbered)
• 1 bag of gray/black embers
37
31
20
32
38
33
Note:
Use of this log set may increase the possibility of
soot formation when air shutters are set to the
minimum setting. Although LT2 units are fitted
with a minimum air shutter stopper intended to
prevent sooting with most log sets, it is possible
some sooting may occur when using this log set
and the air shutter is set to minimum position.
Evaluate the flame picture carefully after the unit
has warmed up for fifteen minutes, and avoid
setting the air shutter to minimum when there
is limited rise in the venting system or the flame
appears overly luminous and lazy with smoke
trailing off the flame tips.
Refer to page 58 for the location and function of
the air shutter adjustment lever.
48
36
28
21
Installation
1. Carefully unpack the kit, as the logs are fragile.
2. Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath.
Installed platform
3. Place log 21 as shown with the pin in the hole. The
left hand side of the log rests gently on the pilot
shield.
21
4. Place log 28 at the right end of the burner. There is a
cutout that fi ts over the right rear corner of the
burner - the log should be placed 1/8" away from
the burner, not directly against it.
28
Fuel Beds
Advertisement
Table of Contents
