Interface Port-Channel Commands - ZyXEL Communications GS-2724 User Manual

38.11.4 interface port-channel Commands

The following table lists the
Use these commands to configure the ports.
Table 91 interface port-channel Commands
COMMAND
interface
port-
channel
<port-
list>
bandwidth-limit
bpdu-control
<peer|tunnel|disc
ard|network>
broadcast-limit
diffserv
dlf-limit
egress set <port-
list>
exit
flow-control
GS-2724 User's Guide
interface port-channel
DESCRIPTION
Enables a port or a list of ports for
configuration.
Enables ingress (pir), cir and
egress limits on the port(s).
Enables the guaranteed
cir
bandwidth limits for incoming
traffic on the port(s).
Sets the guaranteed bandwidth
cir <Kbps>
allowed for incoming traffic on the
port(s).
Enables bandwidth limits allowed
pir
for incoming traffic on the port(s).
Sets the maximum bandwidth
pir <Kbps>
allowed for incoming traffic on the
port(s).
Enables bandwidth limits allowed
egress
for outgoing traffic on the port(s).
Sets the maximum bandwidth
egress <Kbps>
allowed for outgoing traffic on the
port(s).
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
Enables broadcast storm control
limit on the port(s).
Specifies the maximum number of
<pkt/s>
broadcast packets to allow
through the port.
Enables DiffServ on the port(s).
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
<pkt/s>
packets per second (pps).
Sets the outgoing traffic port list
for a port-based VLAN.
Exits from the interface port-
channel command mode.
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
Chapter 38 Introducing Commands
commands in configuration mode.
PRIVILEG
E
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
255