Address Settings At Fieldbus Coupler Using Dip Switches; Technical Data; Safety - Fronius Profinet Robacta CTC Operating Instructions Manual

Address settings The DIP switches on the fieldbus coupler are used to select different addressing
at fieldbus coup- options and the Profinet name. The device conforms to Profinet standards when
ler using DIP -
switches -
All other modes are available as options.
NOTE!
You must restart the fieldbus coupler to apply any changes made to fieldbus
coupler address settings.

Technical data

The technical data of the fieldbus coupler can be found under:
www.beckhoff.com

Safety

Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
▶
Danger from unplanned signal transmission.
This can result in serious personal injury and damage to property.
▶
DIP switches 1-8 are set to - OFF -
DIP switches 9 and 10 are set to - ON -
WARNING!
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
WARNING!
Before starting work, switch off all the devices and components involved and
disconnect them from the grid.
Secure all devices and components involved so they cannot be switched back
on.
WARNING!
Do not transfer safety signals via the interface.
33