Table of Contents
Advertisement
3. Cabling
Connecting to a Terminal or Laptop Computer
Procedure
To connect the Hotwire 8610 DSLAM chassis to a terminal or laptop computer:
3-4
1. Connect the serial cable with 8-pin modular plugs on each end (provided with
the MCP card) into the MANAGEMENT SERIAL port of the 8610 chassis.
2. Dress the serial cable under the 8610 chassis, to the left and behind the left
support foot.
3. Plug the other end of the cable into the terminal or laptop computer serial port,
using the appropriate DB25 or DB9 adapter that is supplied with the MCP
card.
5
4
6
3
2
1
STACK
POSITION
To Terminal
Serial Port
4. Configure your terminal or terminal emulator with the following settings:
— Baud Rate = 9600
— Data Bits = 8
— Parity = No Parity
— Stop Bits = 1
— Flow Control = XON/XOFF
— Terminal Type = VT100
April 2001
10/100 BASE T
MANAGEMENT
IN
OUT
SERIAL
ALM INTF MCP/1
2
3
00-16325-01
8610-A2-GN20-10
Advertisement
Table of Contents
