Connecting An Scp Card To A Terminal Or Pc; Connecting To A Modem For Remote Management (With Scp Card) - Paradyne 8820 Installation Manual

5. Cabling: Test Access SIM

Connecting an SCP Card to a Terminal or PC

Procedure
To connect an SCP card to a terminal or PC:

Connecting to a Modem for Remote Management (with SCP Card)

Before connecting the 8820 BAC to a standard AT dial-up modem, configure the
modem with the following settings:
Procedure
To connect the 8820 BAC to a dial-up modem:
5-4
1. Connect the serial cable with 8-pin modular plugs on each end (provided with
the SCP card) into the SCP Serial port of the SIM.
2. Dress the cable to the right and through the cable retainer.
3. Plug the other end of the cable into the terminal or PC serial port, using the
DB9 adapter that is supplied with the SCP card.
4. Configure your terminal or terminal emulator with the following settings:
— Baud Rate = 9600
— Data Bits = 8
— Parity = No Parity
— Stop Bits = 1
— Flow Control = None
Set the modem for auto answer. For example, ATS0=1.
Turn off character echo. For example, ATE0.
Enable result codes in originate mode only. For example, ATQ2.
Set the modem to ignore Data Terminal Ready (DTR). For example, AT&D0.
1. Plug a serial cable into the SCP Serial port of the chassis.
2. Dress the cable to the right and through the cable retainer.
November 2004 8820-A2-GN20-80