Connecting To The Ipc, Ethernet Hubs, Or Switches; Hot Insertion Or Removal Of The Sim - Paradyne 8820 Installation Manual

4. Cabling: Standard SIM

Connecting to the IPC, Ethernet Hubs, or Switches

Use this procedure for connecting RADSL, MVL, ReachDSL/MVL, IDSL, and
SDSL cards to the IPC, Ethernet hubs, or switches. For other types of cards, refer
to the appropriate Installation Instructions.
Procedure
To connect the 8820 BAC to the IPC, Ethernet hubs, or switches:

Hot Insertion or Removal of the SIM

If the port-card Ethernet interfaces are not being used, it is possible to remove the
SIM without disrupting user data. However, if the user terminal (console) or
10BaseT management interface is connected, the management interface of the
BAC will be interrupted. Also, the MAC addresses of the management interfaces
will be redefined by the new SIM.
The SCP card must be reset when the SIM is removed or inserted.
4-6
1. Plug an 8-pin modular UTP CAT5 cable into LAN jack Port 1 for connecting the
LAN wiring from the line card in Slot 1. Repeat this step for jack Port 2 for the
line card in Slot 2, etc.
2. Dress the cable(s) to the right and through the cable retainer.
LAN Slot
Port 1
CLOCK SERIAL AC
2 4
A MCP ALARM
B SERIAL ALARM
1 3
CLOCK SCM
3. Plug the other end of the cable into your IPC, Ethernet hub connector, or
switch.
November 2004
LAN SLOT
6 8 A 10 12 14 16
18
5 7 9 B 11 13 15 17
99-16559
8820-A2-GN20-80