Split Cable Bushings - Paradyne 8820 Installation Manual

Split Cable Bushings

Eighteen split cable bushings are shipped with the BAC. These bushings keep the
rear cables in place and protect them from being damaged by the cable
management brackets.
Procedure
To install the split cable bushings:
When you have correctly installed the split cable bushing, it points toward the
center of the chassis with the large diameter ring flush against the outside of the
cable management bracket, holding the cable in place.
8820-A2-GN20-80
1. Dress the cable of connector 1 to the right and through the slotted hole that is
second from the top (top hole is not used) of the cable management bracket.
NOTES:
— Cables from connectors 1 to 8: dress to the right.
— Cables from connectors 10 to 18: dress to the left.
2. Taking one of the split cable bushings, open the bushing and slip it over the
cable on the outside of the cable management bracket.
3. Slide and snap the bushing into the slotted hole of the cable management
bracket.
4. Repeat this procedure for each of the remaining cables.
CAUTION:
Do not block the air vents on the side of the chassis with the cables.
Side View
Split Bushing
Shipped Loose
(Field Installed)
Cable
Management
Bracket
Air Vents
November 2004
3. Cabling: Line Card Tip and Ring
Rear View
Customer's Network Cables
18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
Ground
Lug
00-16164a-03
3-5