Telco 50-Pin Connector Pinouts For Dsl Loops And Pots Splitters - Paradyne 8820 Installation Manual

A. Pinouts

Telco 50-pin Connector Pinouts for DSL Loops and POTS Splitters

The 18 Telco-type 50-pin connectors on the rear of the chassis provide the 2-wire
loop interface from each DSL port to either the POTS splitter card or, if the loop is
not being shared with POTS, to the Main Distribution Frame (MDF). The following
table lists the pin assignments for each of these interfaces.
Pinouts for DSL Ports for Each Slot
A-6
Port Pins Port
1 1, 26 13
2 2, 27 14
3 3, 28 15
4 4, 29 16
5 5, 30 17
6 6, 31 18
7 7, 32 19
8 8, 33 20
9 9, 34 21
10 10, 35 22
11 11, 36 23
12 12, 37 24
25
NOTE:
The above table lists the port assignments of the slots and their respective
connectors for 25 ports. DSL port cards with less than 25 ports have their
ports assigned in ascending order starting with port 1. For example, a 12-port
line card uses Ports 1–12, while Ports 13–25 will not be connected by the port
card.
November 2004
Pins
Pin
Number 50
13, 38
14, 39
15, 40
16, 41
17, 42
18, 43
19, 44
20, 45
21, 46
22, 47
23, 48
24, 49
25, 50
Pin
Number 1
00-16714
8820-A2-GN20-80